OnCourse Software

Dave, I had tried that earlier with no success. Didn't work today either. Can you do the KTPA approach and let me know what your PF3 displayer shows as the correct approach frequency. I have 118.15. Any other ideas?
pck42

You need to activate PF3 Display from the PF3 advanced options 'Use PF3 / WEB Display'. Yours is currently not selected

Dave, yes that log I did not have PF3 Displayer checked because I was only addressing an approach problem. I was using an incorrect frequency. Pf3 frequency of 132.35 is not shown on my airport chart and I was using 118.15)

I was using a chart because I am unable to get PF3 Displayer to work. As show in the earlier post the message "PF3 must be running and connected to FS...." No port number is assigned. I have attached a new debug log and PD3 Displayer is checked with port 1010 assigned. I do run the displayer as administrator but still no success. Not really sure that my activating PF3 Displayer will actually show up on the log. but i do try it several times at the runway and before taking off.

What now sir, perhaps a deeper layer of debug. Your continued effort is appreciated.
pck42

Hi Dave, Last week I spent almost 2 hours with Dell Technical Support. Bottom line is that (as we know) for whatsoever reason PF3 Displayer does not recognize PF3. Port 1010 is working properly, just not with the Displayer. I have attached a new debug log and PD3 Displayer is checked with port 1010 assigned. I do run the displayer as administrator but still no success. Not really sure that my activating PF3 Displayer will actually show up on the log. but i do try it several times at the runway and before taking off.

In addition, I have attached several other files that might help pinpoint the issue. Any help from you, your team or the person who wrote the program would be appreciated.
pck42