OnCourse Software
http://www.ocs-support.co.uk/forums/

PFE Display does not show up
http://www.ocs-support.co.uk/forums/viewtopic.php?t=735
Page 1 of 1
Author:  twilfert [ Fri May 13, 2011 5:35 pm ]
Post subject:  PFE Display does not show up

After a re-installation of PFE the PFE display only shows up when 1.) I check in to tell me the right frequency and 2.) when I start taxiing telling me that the Taxi monitor is active.
All other ATC communication is not shown (I can only hear them).
Has anyone also had this issue and found a resolution for it?

Thanks very much for your help in advance!

Author:  Andydigital [ Fri May 13, 2011 6:23 pm ]
Post subject:  Re: PFE Display does not show up

Have you enabled closed captions as mentioned in the thread below?

viewtopic.php?f=4&t=59&p=156&hilit=Closed+captions#p156

Author:  twilfert [ Fri May 13, 2011 6:50 pm ]
Post subject:  Re: PFE Display does not show up

Andydigital wrote:
Have you enabled closed captions as mentioned in the thread below?

viewtopic.php?f=4&t=59&p=156&hilit=Closed+captions#p156
Hi Andy,
this was the mistake. Now it works :)
Thank you!

Cheers Tilo

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited