OnCourse Software

Hi, I fly today from EKCH to EDDM. All works well first and I get the clearence for takeoff. But after that there was no switch to depature. I see, that the frequenzy was changing in the COM´s, but I hear nothing. I pause the sim, disconnect PF3. Reconnct it and unpause the Sim. When I push the 0 Key I get the message that I have to check my COM1 freq.. I see that it switch again during the flght, but no sound to hear. Than I check the PDF of my flight to see the freq. but when I put it in, after a few second it change again.
Roland

New flight. EDDM - LPPR. All works well until I been airborne. The tower gave me the clearance for TO and after that nothing is to hear. Only the frequ. changed .
Roland

Hi, I disconnect PF3. Connect again and use the Depature Frqu. Then I get an answer. But in this time I climb to FL 360 and was far away from EDDM. After a while, I get some frequ-change from ATC and it seems, that it works now. But what happend after clear for takeoff?
Roland

If your COM is changing on it's own then it's not PF3 doing it unless instructed to do so by atc

Hi, what kind of ATC do you mean? I switch all off in MSFS

Here ismy last file from yesterday evening

Hor1463 wrote: *

Wed Feb 16, 2022 10:10 am

Hi, what kind of ATC do you mean? I switch all off in MSFS

Have you for all the pilot assist options off too?