OnCourse Software

Greetings

I am studying PFE, as a new user, before flying with the program. Here's what I've done:

-set the cruise in PF2000 as per the manual
-set various options in PFE
-converted several FS flight plans
-adusted the flight plans to align with PFE
-compiled a couple of flight plans using PF2000

Now here's where I got stopped. The flight plan compiled. I then went back to PFE to select a new adventure, but the selection screen is blank.
In PF2000, the FS2000 path is C:\Flight\FS_ADD~1\PFE\FS2000 (I didn't install in program(x86) file). The APLC path is C:\Flight\FS_ADD~1\PFE\FS2000\Adv
I went to the adventure folder and the contents are:
-Wav folder
-Aplc32.exe
-2 flights each with .adv, .brf, .gps files
-WAPLC32.EXE

Could you help me sort this out? Thanks for reading this. Thanks for your help.

Graham

viewtopic.php?f=4&t=409

If not done so,check out my tutorials to help you get started.

Something is amiss,maybe abit more info from start to finish as what you did so we can trace back.

Thanks

Follow the steps in THIS TOPIC and all should be fine

To the 2 Daves (reminds of the 2 Ronnies...that's a compliment)

I must apologize. I'm afraid I wasted your time.

First, I didn't set the debug level in options originally. I left it at 0 based on the don't change unless instructed caption. I probably missed this
when I read the manual and watched the video. I reset the debug level to 5.

Instead of deleting the ini file, I renamed it. I usually do that. The new ini file correctly found the adventure file folder. I looked at the old file and the
the adventure file folder was set as ...\test\... I'm not sure why I was so dumb to miss that either.

At any rate...all is well for the moment. I'm sure I'll be nagging you again at some point.

Thanks
Graham