OnCourse Software

HELLO everyone!

I Just purchased PFE Because i loved it from watching youtube videos which made me so excited to try it,

and finally after two days from reading the manual and watching tutorials i have successfully made it step by step and finished a PFE flightplan "YAY"!

Sadly every time i run the FSX and press "Shift+Ctrl+0", the display shows me the following

"you are not tuned to any facility, Check your comm1!"

I've checked it and its already right the same as shown, and am in the same airport, so what's wrong? (

BTW: I Have tried most of my aircrafts, FS default and addons, But its always the same message!

I get fed up from that :'(

PS: Sorry am not English so my language is little missed :/

I Hope you reply on me as soon as possible, and i appreciate it!

I contact clearance with just the zero key (NOT CTRL-SHIFT-0)

The zero key above the O and P letters, not the one on the keypad.

Yes its the same

Thanks anyway for the quick reply

PFE is a great program, using it for years. No doubt somebody will offer advice re your problem shortly.

toriu wrote:

PFE is a great program, using it for years. No doubt somebody will offer advice re your problem shortly.

I know!
Am dying to play FSX with it :/

I hope that PFE support will not disappoint me

Thanx!

Hello!

I've finally recognized the problem, its not from PFE

the frequency should be "123.120" but my frequency was "123.125"

I cant change it to .120, its either .125 or .110

Any suggestions?

Make sure your regional setting is set to English.

Try running makerwys and rebuild the PFE database.

Also are you running latest version 2.14.

Dave Leesley wrote:

Make sure your regional setting is set to English.

Try running makerwys and rebuild the PFE database.

Also are you running latest version 2.14.

Yes am running the latest version 2.14

I have rebuilt the database again and still facing the same problem

To Clarify:
I'm @ Hamburg Airport, Germany
After tuning in the ATIS correctly,
PFE wants me to tune in (For clearance) 123.12 and that's impossible in com1, as i know it should be 123.125

Where do you have PFE installed?

I have windows 7, so i've installed it outside the the program files x86, at the (C:) hard drive where my FS already installed there.

Am now trying to reinstall it again.