OnCourse Software

Im trying in vain to load the CRJ 200 bombardier to performance editor. Does any one have a profile to share?

Hi,

there is one in the AVSIM library :

http://library.avsim.net/search.php?Sea ... &Go=Search

cheapcharlie wrote:

Im trying in vain to load the CRJ 200 bombardier to performance editor. Does any one have a profile to share?

I've done a profile for Wilco's CRJ fleet 2004 if thats the one you want,you can download it from www.flightsim.com Avsim or from our site in the downloads section...

Thanks guys will have a look now

Dave Leesley wrote:

I've done a profile for Wilco's CRJ fleet 2004 if thats the one you want,you can download it from http://www.flightsim.com Avsim or from our site in the downloads section...

Dave when I paste that it shows no match

goto www.flightsim.com,log in and search for FDC or Dave Leesley,you should see all profiles i have done,then look for CRJ 200 or Wilco Fleet 2004,it's definately there...

Dave I found this for the crj 2000


===================================================================================================

These are the FDC version 1.3 performance and checklist files for the
PROJECT OPEN SKY Bombardier Canadair Regional Jet / CRJ 600 - 200
for fs2002.

I used the zips mentioned down below. Because there is some disagreement
between flap settings in the air file and the panel configuration, i
made the following change to the aircraft.cfg file to solve this:

[flaps.0]
type = 1 // 1 - tail, 2 - lead
span-outboard = 0.8 // 0.0 .. 1.0
extending-time = 21 // seconds
flaps-position.0 = 0 // degrees
flaps-position.1 = 10 // degrees
flaps-position.2 = 20 // degrees
flaps-position.3 = 40 // degrees
damaging-speed = 220 // KIAS
blowout-speed = 280 // KIAS

Copy and past this flaps part over the one that's in the aircraft.cfg file
and it should work fine.

(The first flap position is called 10 because flaps 8 on the panel, is not
supported by FDC)

===================================================================================================



The read me says to paste the flap settings in the config file which is straight forward but

Im at a loss as to how to load it in the FDC. I go to "not listed" in the drop down and see the flaps settings boxes. What do I do from there

http://www.oncourse-software.co.uk/fdc_downloads.htm

Goto this link and download Wilco Regional from our website.

It's profile for CRJ200/700 series,try and let me know how you get on...i'd delete that profile you downloaded as it's for v1.3 (very old)