OnCourse Software

Hello. I have a problem. I stand in LSZH, and i hear the atis. "Information B, runway 16 in use......."
Thats okay. Now i contact clearence, and then i contact Ground atc for taxi. Now he ge me runway 28 for takeoff?
After that i try call him with ctr-shift-w for other request runway,but it will not works. After that i tryed switch to tower freq.
and i made ctr-shift-w again. NOTHING

I fly the level-d767 and most i need a long runway. The rwy28 is to short. I tryed the funktion in pro flight2000 "Request Long Runway". But this work not,too.Allways i become the rwy 28.
I use active sky6 and fsx. Pfe is on my client via widefs.
Can you help me please?

Pfe will give you the same runway in use by ai traffic or if not detected the correct runway according to wind direction. You can request any runway you wish (see the manual) or close any runway for takeoff our landing

Sent from my Samsung Galaxy S

dmarch wrote:

Pfe will give you the same runway in use by ai traffic or if not detected the correct runway according to wind direction. You can request any runway you wish (see the manual) or close any runway for takeoff our landing

Sent from my Samsung Galaxy S

Hey I know that, but i will not close or open Runways in Pfe settings. I like only Request a other Runway. And this work not. I call clearence atc and he give me the rwy 28 or other,this is no problem,but now i will request a other runway.
which time i can do it? allways i press ctl-shift-w after clerance atc,or ground atc or the tower...is not works.

I think one of the first steps is you have to disable the TGS first, then you can hit the ctrl shift w button and cycle through the runways until it shows you the one you want, do you have that neat little pfe display program running, it will show you a list of all available key commands for the freq your tuned to, very helpful.

MrSpeaker wrote:

disable the TGS first

Hey many Thanks...Now it works

As I said earlier.... Check three manual

Sent from my Samsung Galaxy S