OnCourse Software

Hi Dave!
Jonathan here again. I´ve had some other problems now. Atc claims that I´m off the airway when I´m not, plus atc doesn´t give me any climb instructions!
What is wrong here. I´m really frustrated now, you fix one problem and then the next shows up!!!
I´d really appreciate some help from you, you´re doing a great job

( I did send you the debug )

/Jonathan

This as happened to me on some occasions,so this is what i do..
Create a plan using VOR to VOR (navaid) and make sure they are reasonably spaced apart,delete say one or two WP's that are very close together.
As for no climb instructions,Dave M may be able to advise there...

Also if creating a plan using upper or lower airways you can do as i mentioned earlier,delete any WP's that are very close together....i currently use FS Commander,also used FS Build in the past and both can produce plans with lots of waypoints in and close together...

I also used to get the off airway call quite often. Fixed it with the following.
After converting the flight plan to PFE, open "Adjust FS FP for PF2000", then start FSX and when in the cockpit open flight plan and choose the same flight plan (prefixed PFE_).

I tried that with no good result. I take-off, start turning towards the heading i´ve been given (which isn´t correct to my airway, but anyway ) then I follow the climb instructions. At 18000 ft, atc won´t give me any more climb instructions. What is wrong here???? I´m starting to get a really angry!!!!!!!
I do really need some help. Dave March, you did help me with my other problem and you solved it. Any chans you can help me with this one?
Anyway, I do really appreciate your help guys. My fault was just a bitch!

/Jonathan

Any other suggestions from you guys?

You can turn off the nagging completely if you want.

Options 1.

Airway Deviation, set to 0.

The problem isn´t that atc is telling me to change course, it´s like atc think I´m flying a completely different flightplan