OnCourse Software

Sabretooth78 wrote: *

Fri Nov 11, 2022 2:51 am

I'm seeing a similar problem.

Immediately upon connecting to the sim (P3D5), I get the transponder nag followed by the QNH instruction.

For the first couple attempts, the hotkey '0' wouldn't work (I use VCP mode 2 but like to initiate clearance/pb/taxi comms). Even funnier, if I changed frequencies, for instance FSS, it would initiate, but then if I switched back to tower, PF3 Web Display would say "unknown frequency"!

I changed the setting that prompts the VCP to initiate comms upon connection. This appeared to work. I then reset back to the original setting (I initiate comms) and that then appeared to work....however,

I don't hear ATC (MMCZ tower in this case) instructions, nor do they show up on RemoteText. I only know what the instructions were when I hear the VCP reply, and he replies twice. After this things seem to work OK, so far...

Also had a similar issue near TOD when I requested lower; didn't hear a response from Center but the VCP acknowledged a response.

log.zip

Quote:

I'm getting the transponder nag as well, but it's not until I tune in one of the ATC frequencies, like ground or tower.

dmarch wrote: *

Sat Nov 12, 2022 3:24 pm

One thing I noted with your previous log is you'd defined and oceanic section and also had a STAR starting within that section. Consequently you were cleared for that STAR whilst still under oceanic control, which of course is incorrect. That in turn lead to you being handed off to an incorrect control center, which doesn't exist, so you didn't hear that call due to an internal error of trying to play a control centre that wasn't there. So. I think I need to prevent being able to create a STAR entry within an oceanic section and that, I think, will cure the problem you experienced.