OnCourse Software

Hello Dave.
This ATC response you addressed to me in an earlier post, saying it was a bug to be fixed since 360 was not the right course heading. Not yet sir. It's not really a problem but I am vexed by two issues. Under what circumstances whould I..
(1) Request Vectors and get them instead of "Unable etc"
(2) Request ILS approach and be allow to configure for that instead of "Unable etc"
pck42

Quote:

(1) Request Vectors and get them instead of "Unable etc"

You were already in landin mode and receiving vectors from Approach, so why did you request vectors anyway?

Quote:

(2) Request ILS approach and be allow to configure for that instead of "Unable etc"

If that happens again please include a log file for me to see

ok Dave,
Log is attached for ILS "Unable"
pck42

I see you're flying VFR FF... when approaching your destination just use the Hotkey #1... see if that helps

Hi Dave, Unfortuately Hotkey #1 did not help. In fact (hope you can seen the log), it changed my radio from Approach (122.65) to 122.90, which was not a KTPA frequency. Hope the log gives you some clues!
pck42