OnCourse Software

Guys

Is there anyway that I can force PF3 to use a particular speaker setup on my PC? Currently I have a 5 speaker set for general PC sounds and this is also used as the default playback device for P3D. I also have built in speakers in my monitor which I used for the voice only setting in P3D.

Since PF3 uses the same default sound device as P3D sometimes the sounds can get lost. I know I can adjust the other sounds to compensate but it would be better if I could map PF3 to my monitor speakers the way I can in P3D for voice.

Thanks and enjoying this software immensely

That has been discussed on this forum a few times

Have you tried this https://github.com/audiorouterdev/audio-router

Thanks Dave

I did try searching but my keywords must have been slightly different. I will give this a go.

Best regards

Ken