OnCourse Software

Hi,

can some1 tell me what went wrong. PF3 stopped responding somehow?.

Using fsx, mce and pf3. Created a flightplan EHAM-LEMD.
Till contacting dep everything was ok.
Then i had to contact Amsterdam center on 125.75. I rogered that.
But couldn't established contact.
I've stopped the flight short after that

Further i have to say i'm addictive to this program (coming from rc4)

Best regards John

Well this is very strange and I don't remember ever seeing this before.... your log file simply stops... no error messages at all.

Did you see any messages?

Hi Dave,

No nothing. Have tried couple of times to contact by voice and then pressing ,don't know how many times, the 0 button.
Then i tried to request fl350.
Still nothing. Couple minutes after that i quit my flight.

1st time my flight was not suc6 full .

Best regards John

starter wrote:

Hi Dave,

No nothing. Have tried couple of times to contact by voice and then pressing ,don't know how many times, the 0 button.
Then i tried to request fl350.
Still nothing. Couple minutes after that i quit my flight.

1st time my flight was not suc6 full .

Best regards John

Are you sure you are pressing the correct hotkey?

Hi,

Always when i've trouble with voicecontrol, i'm pressing the "0" (zero) button to establish contact.
I've also tried higher alt. No response either.
When pressing the "\" it ack. the freq change to 125.75.
Then i tried to contact "center" again by voice. See the red lines but nothing happend.
After pressing again 0 (zero) and 1 or 6 and change back to dep freq. with no response i quit the flight.
What i also remember after taking a look at the displayer (before i quit) there was no key commands available in that table.



Best regards John

Hi,

Did the same flight. Now it went smooth as ice .
@vololiberista: tried to check in by voice and pressing the 'zero' button and that works.
So yes i'm certainly using the correct button .

Also saw that the pf3 displayer also worked fully.

Best regards John