OnCourse Software
https://www.ocs-support.co.uk/forums/

Version 3.13.0 TGS stand-alone module
https://www.ocs-support.co.uk/forums/viewtopic.php?t=3804
Page 1 of 1
Author:  Granman [ Mon Jan 10, 2022 12:41 pm ]
Post subject:  Version 3.13.0 TGS stand-alone module

Hello,

Thanks for latest update on PF3. I installed the update but don't see this additional 'red dot' showing the next to next taxiway point. Is there anything I need to do to see it or way to make sure it updated correctly?

Regards,
Marc

Author:  Dave March [ Mon Jan 10, 2022 5:40 pm ]
Post subject:  Re: Version 3.13.0 TGS stand-alone module

Please check the version number of your TGS_Display.exe. It should be 1.1.3

Author:  Granman [ Mon Jan 10, 2022 6:02 pm ]
Post subject:  Re: Version 3.13.0 TGS stand-alone module

It still shows as version 1.1.0.0. I ran PF3 again and tried to update but it says there are no further updates.

I attached the update log that shows an error at the end of the update, but not sure there is any relation.

Thanks,

Marc

Author:  Dave March [ Mon Jan 10, 2022 6:49 pm ]
Post subject:  Re: Version 3.13.0 TGS stand-alone module

Well, looks like that one slipped through the net

Please unzip the attached into your PF3\TGS_Gauge folder

Author:  Granman [ Mon Jan 10, 2022 7:53 pm ]
Post subject:  Re: Version 3.13.0 TGS stand-alone module

I extracted it there and will try a little bit later. I did notice that the version shows 1.1.0.3, not the 1.1.3 as you mention.

Author:  Dave March [ Tue Jan 11, 2022 11:47 am ]
Post subject:  Re: Version 3.13.0 TGS stand-alone module

Version is correct. My development platform drops the third digit for some bizarre reason. I've been using it for almost 40 years and still not used to it.

Author:  Granman [ Tue Jan 11, 2022 1:34 pm ]
Post subject:  Re: Version 3.13.0 TGS stand-alone module

Sounds good and that seemed to fix the issue.

Thanks for your promptness, as always!

Marc

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited