Hi Guys,
Looking for a little help or advice because i must be doing something wrong.After using RC4 for a good few years,i heard about PF3 and decided to purchase it today,well im rather disappointed with it to be fair.first off RC4 cant read all your altitudes in the flight plan,Via SID and StARS.with this i have to put them in myself.So i thought i would give it a go anyway after reading the manual i set a flight up from EDDF to EGLL,I started the flight and thats where the issues started,first off i could tune to the ATIS so i had to guess it was 7C for departure due to the winds,i started the programme by pressing 0 and it had me taxing to the runway before i could even switch the aircrafts power on,contact ground when ready to taxi,well i wasnt but the co pilot just kept asking for the next step.I set the aircrart up and made my way to 7C for departure at the holding point i didnt recieve a single message to enter the runway so i pressed 0 again and it told me to continue taxi,this happened 5 times with no acknowledgement that i was at the holding point,at that stage i turned it off and restarted the flight RC4,i hope i am doing something with regards to reading the SIDS and STARS being input manually and why i am getting all the instructions to taxi etc when im not ready,got a feeling this will be going back in the box and i will go back to trusty RC4,hope you guy can highlight where i am going wrong.
With Thanks
Gary.