OnCourse Software
http://www.ocs-support.co.uk/forums/

Problem setting comm frequency
http://www.ocs-support.co.uk/forums/viewtopic.php?t=60		 Page 1 of 1
Author:  briane [ Fri Jun 05, 2009 3:40 pm ]
Post subject:  Problem setting comm frequency
Hi,

I've come across a small problem that I hope you can help me with, while using the Wilco 777 and attempting to setup PFE, comm1 does not adjust to the correct frequency at which time I receive a popup Stating :- comfreq: 121.76 < > clearancefreq121.75. On transferring to comm2 it does setup 121.75, but there is no communication, however if you select ATIS freq. it is loud and clear. Thinking there may be some solution in fax or on the support forum, but came up with nothing.

I also added the upgrade to 2.11 hoping this may address it, it didn't. Have you any pointer as to what I should do next? (polite answers only!!)

Nice software,
briane
Author:  Dave March [ Fri Jun 05, 2009 5:29 pm ]
Post subject:  Re: Problem setting comm frequency
So what happens when you dial the correct clearance frequency into COM1

When you first start PFE it does not automatically tune your COM radio for you
Author:  briane [ Sat Jun 06, 2009 9:25 pm ]
Post subject:  Re: Problem setting comm frequency
Hi

as I said:-
briane wrote:
I receive a popup Stating :- comfreq: 121.76 < > clearancefreq121.75.
The image refers to comm2
[ img ]

And I am aware of your second point.

Regards

briane
Author:  Dave March [ Sat Jun 06, 2009 11:26 pm ]
Post subject:  Re: Problem setting comm frequency
So I'll ask again... what happens when you tune the CORRECT frequency into COM1 ?

Does this only occur with the Wilco 777. I don't have that aircraft so can't try it myself. Perhaps COM1 and COM2 are internally wired (coded) incorrectly
Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited