OnCourse Software
http://www.ocs-support.co.uk/forums/

Say again doesn't answer
http://www.ocs-support.co.uk/forums/viewtopic.php?t=508		 Page 1 of 1
Author:  Sabre [ Sun Jul 25, 2010 9:55 am ]
Post subject:  Say again doesn't answer
Hello,

I'm asking Clearance to repeat and never get an answer? My "Say again" is assinged to the free unmodified "u" keystroke that has no conflict with any other fs9/add-on programs. The original ctl+shf+\ didn't seem to work either.

Thanks,
Sabre.
Author:  Sabre [ Sun Jul 25, 2010 10:16 am ]
Post subject:  Re: Say again doesn't answer
Ok, I think I've figured it out. In the manual there must be a typo on page73, whereas it says:
Quote:
So, in summary, 0=Say Again only, 1=Display Log only, 3=Both
I had it on 3, but the text a few lines above already suggested I should use one of these:
Quote:
Setting this to...
SayAgainOp=1
...will only display the new ATC log showing the last 10 ATC commands. In
this mode you will NOT hear the normal 'Say Again' request/reply.
Setting this new option to...
SayAgain=2...will display the new ATC log showing the last 10 ATC commands PLUS you
will hear the normal 'Say Again' request/reply.
Sabre.
Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited