OnCourse Software

If you're still hearing ATC coms to you then there's nothing wrong with your audio setup.

I've been wondering if radio frequencies have anything to do with this issue, because you will only hear AI chatter if they are on the same frequency. If for some reason you get no chatter PF3 will broaden the frequency bandwidth to obtain more chatter, which is what it's been attempting to do according to your logs. I might have to add some additional debug code to ascertain exactly what's going amiss with your setup... let me give it some more thought and get back to you.

Ok, thank you Sir,

Just to let you know, I have a navigraph unlimited subscription

Sincerely,

Carlos

Well I haven't been near the AI interaction code in years but just checked and I already have some debug code in there that 'might' help me. So, here's what I'd like you to do for me please.

Start PF3, select Options #1 and at the bottom left of that screen adjust the debug level to 4

Now start FS and go to a busy airport. Connect PF3 and get your clearance and get to the point where you're told to contact Ground on xxx for pushback/taxi.

Now let it sit there for maybe 10 minutes whilst there is hopefully a lot of ground AI traffic movement.

Finally disconnect PF3 and exit.

Please attach the debug log to your post

Thank you

here it is attached

Thanks,

Sincerely,

Carlos

AMAZING started to hear ATC transmissions.

Just deleted my fsuipc7.ini file, started again FSUIPC, and now I can listen to ATC AI.

Thank you for the support.

Sincerely,
Carlos

Phew, thank goodness for that. Can't think what you may have changed in the FSUIPC.INI file though to stop it working. Pity you didn't save a copy before deleting it so we could take a look. Maybe it's still in your recycle bin?

Thanks for the update

Hello Sir

Yes, usually before I delete something, I make a backup. Will send you later in the evening.

Sincerely,

Carlos

Excellent, thank you

Attached my old fsuipc.ini

Sincerely,

Carlos

cteixeira wrote: *

Thu Oct 26, 2023 11:32 pm

Attached my old fsuipc.ini

Sincerely,

Carlos

Thank you... here's the problem....

In your FSUIPC.INI file there's an entry named ProvideAIData and you're was set to NO

This is from the FSUIPC documentation

ProvideAIdata=Yes:. Set to No to stop FSUIPC reading any AI traffic data.

Certainly had me stumped and now I'll add it to our FAQ's just in case I forget... no, WHEN I forget!