| OnCourse Software http://www.ocs-support.co.uk/forums/ |
|
| Altimeter/QNH error http://www.ocs-support.co.uk/forums/viewtopic.php?t=4320 |
Page 1 of 1 |
| Author: | martinlest [ Sun Oct 15, 2023 4:31 am ] |
| Post subject: | Altimeter/QNH error |
I haven't been able to run 3.21.5 beta (I get an error window when I try - DaveM is aware of this  ), so am on 3.21.0: in this version at least, when I have the option "Use QNH instead of Altimeter for non-US" unchecked (=off?), barometer settings are being given as 'Altimeter is 1013' instead of 'Altimeter is 29.92'. (With the option checked, I get 'QNH is 1013', which is correct of course. |
| Author: | Dan77 [ Sun Oct 15, 2023 8:50 am ] |
| Post subject: | Re: Altimeter/QNH error |
| Options #1, Trans Alt & Alt Baro Calls (at bottom), uncheck the small checkbox for each region if you prefer the baro calls in inches |
| Author: | martinlest [ Sun Oct 15, 2023 12:37 pm ] |
| Post subject: | Re: Altimeter/QNH error |
| OK, will look at that. I thought the setting I mentioned was 'global'. Thanks. Later: Ah yes, now I see it, it all comes back to me (long time since I have actually had to set up PF3 from a fresh install)! I'd forgotten all about that page. Thanks again. |
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited | |