| OnCourse Software http://www.ocs-support.co.uk/forums/ |
|
| No ATC after Takeoff http://www.ocs-support.co.uk/forums/viewtopic.php?t=3943 |
Page 1 of 1 |
| Author: | cyberspace2019 [ Wed May 04, 2022 10:38 am ] |
| Post subject: | No ATC after Takeoff |
| Hello! It's all good until after the takeoff all radio traffic is gone. I've tried everything but no success. |
| Author: | Dave March [ Wed May 04, 2022 12:24 pm ] |
| Post subject: | Re: No ATC after Takeoff |
| Shortly after your wheels left the ground you changed your radio frequency to 131.33, so you weren't in contact with any ATC facility. Why did you do that? If it wasn't you then you must have Pilot Assist on in the MSFS options to handle radio frequencies, in which case you need to deselect it. |
| Author: | cyberspace2019 [ Wed May 04, 2022 4:01 pm ] |
| Post subject: | Re: No ATC after Takeoff |
| Hello! I fly with FSFO, could it be because of that? |
| Author: | Dave March [ Wed May 04, 2022 4:59 pm ] |
| Post subject: | Re: No ATC after Takeoff |
| Sorry, I have no idea. All I can be certain of is PF3 did not change the frequency, either you or something else did. Have you checked MSFS Pilot Assist options? |
| Author: | cyberspace2019 [ Thu May 05, 2022 4:54 pm ] |
| Post subject: | Re: No ATC after Takeoff |
| Hello! I have found my mistake. If I load the flight plans in MSFS and not via a third-party program, everything is fine. regards from Peter |
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited | |