| OnCourse Software http://www.ocs-support.co.uk/forums/ |
|
| No taxi instructions http://www.ocs-support.co.uk/forums/viewtopic.php?t=3587 |
Page 1 of 1 |
| Author: | maddog453 [ Sun May 30, 2021 10:08 pm ] |
| Post subject: | No taxi instructions |
| The last two times I tried to fly with PF3 I get the clearance for push and start but not any runway or taxi instructions. When I report ready to taxi I get an approval for push and start. If I go ahead and taxi to a runway tower won't clear me. If I take off anyway and contact clearance to increase in altitude it tells me I have to be IFR, which is my flight plan. Thanks Doug |
| Author: | Dave March [ Mon May 31, 2021 11:38 am ] |
| Post subject: | Re: No taxi instructions |
| Hi Doug, The problem here is you are not using the VCP and therefore you have to 'Roger' all ATC instructions. You didn't 'roger' anything at all. |
| Author: | maddog453 [ Mon May 31, 2021 3:15 pm ] |
| Post subject: | Re: No taxi instructions |
| I was using MCE as my communications and she was acknowledging the comms. Doug |
| Author: | Dave March [ Mon May 31, 2021 3:46 pm ] |
| Post subject: | Re: No taxi instructions |
| Not in PF3 it wasn't. I don't know how to setup MCE but it has to pass a hotkey to PF3 otherwise how does PF3 know what you're doing? |
| Author: | maddog453 [ Tue Jun 01, 2021 3:24 am ] |
| Post subject: | Re: No taxi instructions |
| Thanks. I'll double check. Doug |
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited | |