OnCourse Software

Subject displays not maintaining continuity with flightplan.

When WP changes, the PF3Display, bottom left (Last/Next WP), does not update. The only way to get it to update is to go to the radio stack, switch to standby (doesn't matter what the standby freq is) and then back to current CTL freq. Altitude also missing from bottom left; just displays a zero.

Using P3Dv4.5 with PF3 on 2nd PC in WideClient folder. All shares & access coinfirmed. PF3 3.9 always ran 99.9% good and stable within WideClient folder. PF3_Display folder is present in P3Dv4.5 folder with current FPL dat file.

Currently in the middle of a very long FLT and am afraid of loosing ability to resume FLT by going onto options.
Thanks

Finally finished the above mentioned FLT. Same as abv thru whole FLT. Also, from the Persian Gulf to EDDP I was given no freq changes; stayed on 126.70 all the way. Close to EDDP I was assigned a rwy but had to tune radio myself.
Am using CP mode 2.
Will try turning off the P3D MSFS options.
I'd go back to v3.9 but wud like to take advantage of new voices & phrases.
rgds

I'm afraid it's a little difficult to comment on this flight as you appear to have done it in stages, using PF3's restart feature, so I only have two sections of the flight rather than the complete flight. I also noticed you have used accelerated Sim Rate, which I don't support as it can result in some untoward things happen.

If you get these same problems during a normal flight, when not using acceleration, then please report them again and I'll take a look

I understand about the acceleration; but I didn't start 2x accel until long after I was stuck on 126.70.
Thanks for response. I will try another shorter FLT and report back.
Happy New Year!
W

Waypoints do not immediately update in displayer and lower part of displayer goes away and does not show up again until com freq is updated or switched to standby and back to current com freq.

Waypoints update but not until reaching the next WP. If I have WP A, B and C; coming from A to B there is no update to B until reaching C.

The FLT I did fm EDDP to LEMD went OK except for above. I got regular center handoffs.

The only things I did during the FLT was to cycle through VC's, exit and restart displayer and swapped stby & active freqs.

Thanks.

miraclemax wrote: *

Thu Dec 31, 2020 10:38 pm

Waypoints do not immediately update in displayer and lower part of displayer goes away and does not show up again until com freq is updated or switched to standby and back to current com freq.

Waypoints update but not until reaching the next WP. If I have WP A, B and C; coming from A to B there is no update to B until reaching C.

The FLT I did fm EDDP to LEMD went OK except for above. I got regular center handoffs.

The only things I did during the FLT was to cycle through VC's, exit and restart displayer and swapped stby & active freqs.

Thanks.

I have the same issue as you describe.
Thank you.

Richard.

I'm another flt now from LEMD to LTFM and same problem. Richard, attach your logs also, if you still have them. I think I may have to go back to 3.9.
regards

Please, any news on this? This issue occurs on all flights!

Thank you,
Richard.

I'll try and have a look at it later today... sorry for the wait

dmarch wrote: *

Fri Jan 08, 2021 1:22 pm

I'll try and have a look at it later today... sorry for the wait

Fine, thank you...

Richard.