| OnCourse Software http://www.ocs-support.co.uk/forums/ |
|
| Can't check in or get started http://www.ocs-support.co.uk/forums/viewtopic.php?t=2360 |
Page 1 of 1 |
| Author: | nick_43 [ Sun Dec 11, 2016 5:46 pm ] |
| Post subject: | Can't check in or get started |
| Hi, having problems checking in with clearance. I get the intro maessage and flight plan is loaded, tuned to clearance and hit the hotkey zero but don't hear my callsign, just other AI callsigns, same with ground. The only time so far it has worked was restarting a flight mid air and i heard the controller using my callsign but it didn't hand me over to other controllers, just asked me to descend and that was it, so was just that segment of the flight. Any ideas? would be much appreciated. thanks |
| Author: | Dan77 [ Sun Dec 11, 2016 6:15 pm ] |
| Post subject: | Re: Can't check in or get started |
| Please zip and post your PF3\Logs folder so we can have a look. The file must be zipped to be attached to your post. |
| Author: | nick_43 [ Sun Dec 11, 2016 6:23 pm ] |
| Post subject: | Re: Can't check in or get started |
| here's the log, thanks |
| Author: | ThomasAH [ Sun Dec 11, 2016 9:49 pm ] |
| Post subject: | Re: Can't check in or get started |
| I don't know if this causes the problem, but your FSUIPC is a bit old: 4.949F might be too old for your version of P3D, please upgrade to 4.958. Your log does not show any pressed hotkeys. Did you press "0" in the top row (above O and P on US layout), or on the numeric keypad? Default config for PF3 is to only accept the numbers in the top row. |
| Author: | nick_43 [ Sun Dec 11, 2016 10:06 pm ] |
| Post subject: | Re: Can't check in or get started |
| Thanks for the tip about fsuipc, will upgrade it. I did press the numbers on the top row but them not registering would make sense as it doesn't seem to be doing anything, just don't know what could be causing it. Thanks for your help. |
| Author: | nick_43 [ Thu Dec 15, 2016 9:21 am ] |
| Post subject: | Re: Can't check in or get started |
| Hi, I upgraded my fsuipc but it hasn't had any effect on the hot keys, do you know what might be causing them not to register? They are working fine in other programs. Could it be something to do with the configuration (I haven't changed it) or the connection between p3d and pf3? Any help would be appreciated. Thanks, Nick |
| Author: | ThomasAH [ Thu Dec 15, 2016 9:58 am ] |
| Post subject: | Re: Can't check in or get started |
Ah, I just found the reason in your log:
You can either enable it there again, or just edit your PF3.ini to change above to "Hotkey1=1". |
| Author: | nick_43 [ Thu Dec 15, 2016 12:01 pm ] |
| Post subject: | Re: Can't check in or get started |
| Ah thanks, that's great all working now, I must have disabled it when first installed it. Thank you Nick |
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited | |