Might as well do this 'correctly' if I am going to do it at all, so maybe someone could kindly advise me?
Many thanks.
| OnCourse Software http://www.ocs-support.co.uk/forums/ |
|
| Multicom procedure? http://www.ocs-support.co.uk/forums/viewtopic.php?t=2218 |
Page 1 of 1 |
| Author: | martinlest [ Tue Sep 13, 2016 11:57 pm ] |
| Post subject: | Multicom procedure? |
| Just taken off from an airport which only has Multicom... I announced 'Taking the Runway' and 'Departing the Area', but then found I didn't know the correct procedure... What frequency should I then tune to? Nothing happens automatically (mode 2). What is supposed to be happening en route and as I approach my destination? Found nothing on this in the pdf, searching for 'Multicom'. Might as well do this 'correctly' if I am going to do it at all, so maybe someone could kindly advise me? Many thanks. |
| Author: | bobsk8 [ Wed Sep 14, 2016 3:36 am ] |
| Post subject: | Re: Multicom procedure? |
| I would look for a departure or Center Frequency to switch to using PF3 display. |
| Author: | KevinJH [ Wed Sep 14, 2016 9:26 am ] |
| Post subject: | Re: Multicom procedure? |
| And/or contact FSS requesting the frequency for Centre. |
| Author: | martinlest [ Wed Sep 14, 2016 9:51 am ] |
| Post subject: | Re: Multicom procedure? |
| None of the frequencies I tried gave any response - I was perhaps not choosing the right one (I used the nearest). As I neared my destination, ATC suddenly started up ('Resume own navigation') - I had left the NAV radios tuned to the destination Tower frequency- and then continued as normal (nice!). Would PF3 automatically tune to the right frequency anyway in Mode 2 though, or did that only happen because I'd pre-tuned to the destination Tower manually? |
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited | |