Previously, I have used dual video cards on my primary computer implementing three monitors, one which was dedicated to FlightSim Commander which I use to originate flight plans, then convert them with the PFE Emulator. Recently due to a video card failure, I lost the use of one monitor. I have also used a secondary computer with another dedicated monitor for other applications for years which gave me four monitors until the card failure.
As a solution, I chose to install FlightSim Commander on the secondary computer implementing FSUIPC and WideFS/WideClient and have the third and fourth monitors on the secondary computer. Obviously I had to jump through a few hoops in setup to get everything working, particularly mapping my drives. Everything went find for months until recently and I now have the following problem.
I save my flight plans originated in FSC on the secondary computer to my "Flight Simulator Files" or "Flight Simulator X Files in My Documents on the primary computer with no problem. However, when I try to convert them with PFE/FS2000 I am getting a Proflight Emulator error window that tells me, "No change necessary for this Flight Plan or Format Unknown!"
I am puzzled as this was working fine until recently.
I saw that there is an upgrade, so upgraded to version 9.6 Rev.5
For good measure, I installed FSC back on my primary computer, There is no problem at all. The Flight Plans are originated exactly the same on either computer, and are saved in the Flight Simulator Files or Flight Simulator X Files and appear to be exactly the same, but apparently something is being changed in their format.
Note: I have made this same post on the FSC forum.
Any Ideas?
RTH