OnCourse Software http://www.ocs-support.co.uk/forums/ |
|
need help with flaps http://www.ocs-support.co.uk/forums/viewtopic.php?t=1670 |
Page 2 of 2 |
Author: | Dave March [ Tue Jul 21, 2015 10:07 pm ] |
Post subject: | Re: need help with flaps |
Maybe this will help.... it's taken from the FDC version history document:- ADDED a new option on the Select Aircraft page. You will notice I have removed the AGL option next to Descent checks as in all probability that would never be used and if it was it probably shouldn't be <G>. So, the 'or click here' displays a new PFE only message that describes the new option. Basically if you enter an altitude and choose MSL then everything works exactly as it does now. If you select the new PFE Cruise option then the altitude you enter here is subtracted from PFE's cruise altitude to give the altitude at which Descent checks would be triggered. This provides a means by which these checks will be automatically adjusted for each of your PFE flights, even if the cruise altitude is different in each one. There are a few provisos here... IF you select to use this new option but decide not to use PFE then Descent checks will be whatever you've entered, unless it is below the Approach checks, in which case Descent checks will be readjusted to be the same as Approach checks + 2000. Equally, if you have a high figure in the Descent check and choose to use the PFE option... if the Descent altitude is higher than the PFE cruise altitude it wll be reset to PFE cruise altitude -2000. |
Author: | mllgrennman [ Tue Jul 21, 2015 10:40 pm ] |
Post subject: | Re: need help with flaps |
Yes I read that...but when I hit ...."or click here" it says "Set the number of seconds to 999 and Before Takeoff Checks will then commence AFTER you have contacted tower ( in PFE) for takeoff clearance." Nothing about entering altitude--(This is what I meant about seconds) |
Author: | Dave March [ Wed Jul 22, 2015 10:20 am ] |
Post subject: | Re: need help with flaps |
I think you need to read it again You're looking at... Before TO checks..... but it reads... next to Descent checks |
Author: | mllgrennman [ Fri Jul 24, 2015 11:47 am ] |
Post subject: | Re: need help with flaps |
Mine looks different... |
Author: | Dave March [ Fri Jul 24, 2015 1:01 pm ] |
Post subject: | Re: need help with flaps |
Ah ha, just spotted the problem. Sorry I should have noticed before. You're using a very OLD and UNSUPPORTED version of FDC (version 3.90). Please download the cumulative updates package from the forum. |
Author: | mllgrennman [ Fri Jul 24, 2015 3:13 pm ] |
Post subject: | Re: need help with flaps |
I thought of doing that but how is V3.13 newer than V3.90? |
Author: | Dave March [ Fri Jul 24, 2015 6:27 pm ] |
Post subject: | Re: need help with flaps |
3.90 is a typo |
Page 2 of 2 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited |