OnCourse Software
http://www.ocs-support.co.uk/forums/

Having problems with SID and STAR
http://www.ocs-support.co.uk/forums/viewtopic.php?t=1343		 Page 1 of 1
Author:  Fernandobs [ Tue Jul 30, 2013 4:51 am ]
Post subject:  Having problems with SID and STAR
Hi Guys,

I am having a problem with the Set END SID and Set START of Star option.

I cant never get the ATC to allow me to flight a particular approach from the waypoint selected in the waypoint altitude adjustments page. For instance if the waypoint BRAVO was selected for the start of the star I should get the message from atc saying '' "Easy 211 continue via the Sierra Tango Approach... remain on this frequency, I'll have traffic for you'', but its not happening with me. And in regards to the sid, the ATC says for me to resume own navigation based on the initial altitude clearance not when I reach the selected waypoint.

I have the version 2.14 and use fscommander and Active Sky 2012.

Thanks for the helps guys
Author:  kramerdc9 [ Tue Jul 30, 2013 8:32 am ]
Post subject:  Re: Having problems with SID and STAR
You might want to check out my post a couple down. I asked the same question regarding star start. I didn't receive the Sierra Tango Approach either. However, I don't think I had everything set up correctly in FPE and PF2000. If you read the post, look what Dan said regarding FP2000. I didn't know this. Anyway, I'm going to do same route but with correct input in PFE and PF2000. FYI.
Fernandobs wrote:
Hi Guys,

I am having a problem with the Set END SID and Set START of Star option.

I cant never get the ATC to allow me to flight a particular approach from the waypoint selected in the waypoint altitude adjustments page. For instance if the waypoint BRAVO was selected for the start of the star I should get the message from atc saying '' "Easy 211 continue via the Sierra Tango Approach... remain on this frequency, I'll have traffic for you'', but its not happening with me. And in regards to the sid, the ATC says for me to resume own navigation based on the initial altitude clearance not when I reach the selected waypoint.

I have the version 2.14 and use fscommander and Active Sky 2012.

Thanks for the helps guys
Author:  pschlute [ Tue Jul 30, 2013 9:48 am ]
Post subject:  Re: Having problems with SID and STAR
Regarding the SID. If you have a SID altitude set in the SIDS/STARS page, then ATC will start guidance when you EITHER reach that altitude OR reach the end SID waypoint, whichever comes first.

If you dont want ATC to start guidance until a certain waypoint then set the SID altitude to a number ABOVE the altitude you intend to cross the end of SID waypoint at.

Peter
Author:  anubhav100 [ Mon Oct 28, 2013 3:00 am ]
Post subject:  Re: Having problems with SID and STAR
To the OP - did you find a solution to your STAR problem? I have the same exact issue in that the control ignored my start of STAR waypoint and never clears me for the STAR saying "blah blah..remain on this frequency, I'll have traffic for you"
Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited