OnCourse Software
http://www.ocs-support.co.uk/forums/

PF3 Displayer
http://www.ocs-support.co.uk/forums/viewtopic.php?t=4249		 Page 4 of 4
Author:  johnhinson [ Wed May 01, 2024 7:55 am ]
Post subject:  Re: PF3 Displayer
As you know I have had this exact same issue but think I may have found the solution.

I do not have the automatic "Check for Updates" set (and usually have to update manually) but for once I pressed the Check For Updates button on the main screen. This presented me with the Essential Core Update options mentioned at https://www.ocs-support.co.uk/forums/vi ... php?t=4524.

After pressing a few buttons as directed, this carried out the update in a matter of seconds. And, hey presto, the problem has gone! The displayer now works as it should.

So do try this, Doug, to see if it works for you too.

John
Author:  maddog453 [ Thu May 30, 2024 7:57 pm ]
Post subject:  Re: PF3 Displayer
I took some advice and at least it now says its connected. It doesn't show the frequencies or change responses when you change frequencies.

I verified that FSUIPC is on.

I have attached the requested logs and some photos.

Thanks
[ attachment ]
Untitled.jpg (203.63 KiB) Viewed 7243 times
[ attachment ]
Untitled 2.jpg (222.73 KiB) Viewed 7243 times
display.7z
(289.89 KiB) Downloaded 477 times
Author:  pck42 [ Sun Jul 14, 2024 9:34 pm ]
Post subject:  Re: PF3 Displayer
pf3_display.zip
(211 Bytes) Downloaded 374 times
pf3_display.zip
(211 Bytes) Downloaded 380 times
PF3.zip
(2.54 KiB) Downloaded 363 times
PF3.zip
(2.54 KiB) Downloaded 363 times
Hi Dave,

I'm embarrassed to open this up again. Reinstalled FSUIPC, reinstalled PF3 (including make runways). But PE3 displayer will not connect. No port and message that PF3 must be running. IT IS! I have thoroughly looked the at manual and this thread to solve this issue with no luck. So, PF3 or my system? Any advice would be appreciated.
pck 42
Page 4 of 4 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited