OnCourse Software
http://www.ocs-support.co.uk/forums/

Need help with Oceanic crossing using PF3/MCE
http://www.ocs-support.co.uk/forums/viewtopic.php?t=3130		 Page 2 of 2
Author:  PierreNantel [ Sat Apr 27, 2019 1:32 pm ]
Post subject:  Re: Need help with Oceanic crossing using PF3/MCE
Thank you,

In the mean time i will do more crossing end put more info here.

dan77, you could be right, i only use oceanic by default (crossing the atlantic) and i do get the same message at the last waypoint of the crossing, but without the contact xxxx center on xxx.x

No rush it is a hobby after all :lol:

Pierre
Author:  Dave March [ Sat Apr 27, 2019 2:24 pm ]
Post subject:  Re: Need help with Oceanic crossing using PF3/MCE
Thanks Dan

Sent from my mobile using Tapatalk
Author:  PierreNantel [ Thu May 02, 2019 8:54 pm ]
Post subject:  Re: Need help with Oceanic crossing using PF3/MCE
Hi,
I did 2 more crossing with two different flight plans and in both cases the Handoff from SHANWICK OCEANIC to Shannon Control happened but I was not asked to tune 127.50 as a new frequency.

One more thing, on the American cost, I am advised by ATC that I am off my fly path by xx miles. Is this because my route use direct to waypoints? I am not following an Airway?

Thanks again for the help

Pierre
Author:  PierreNantel [ Sun Aug 18, 2019 2:19 pm ]
Post subject:  Re: Need help with Oceanic crossing using PF3/MCE
Hi Dave,

I see that someone else had the same problems, autumn is coming in Canada and it time for me to start me ocean crossing again. Did you ever figured out what was the issue? And should we expect a fix soon?

Thanks for your support

Pierre
Page 2 of 2 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited