OnCourse Software

good
created a flight from Portugal to Puerto-LPPR LEBB bilobau in Spain will deuxar here some pictures of my procedure
I will leave some doubt that happened to me during the flight
flight plan done in fscommnader and then exported to fs2004 and also the same for the pfe2000
the plan done without any problem in pfe 2000 so changed the level of flight to 33000ft here are some pictures


Uploaded with ImageShack.us[/img]


Uploaded with ImageShack.us[/img]



Uploaded with ImageShack.us

till here everything ok






Uploaded with ImageShack.us[/img]
Here begins my doubts and the problems
I had to put the same altitude in the same flight plan fs2004
Because the altitudes of 13000ft pfe2000 get in?
The flight plan I have to replace everything right as I fs2004 in the plan is the same!!
But I think I put everything right until the SID and Star



Uploaded with ImageShack.us[/img]


Uploaded with ImageShack.us[/img]
this image which is the frequency 124.4?
after all normal output without problems after problems begin:
Very low level flight not send me to my level flight 33000ft!!?
After going to the side of the air traffic controller spain remains of Portugal (Lisbon center) should not be Spanish?
then not send down to my destination!!?
other questions
what is fss, multicontro, Unicontrol?

Thank wait for aid

greetings

You are not entering your cruise altitude correctly. The box "Flight Level Altitude" is where ATC will change from using altitude ( example 6'000 feet) to using Flight Level (example FL 60). Change that setting back to either your local transition altitude or you can use 0 to enable regional transition altitudes. You need to use the box "cruise Altitude" to enter your cruise altitude

Freq 124.4 is what your radio is currently set to. You need to use 118.00 to contact tower

thank pschlute
but if you notice I have already placed the box in level flight to 33,000 ft and he rises to it!!

paparomeu wrote:

thank pschlute
but if you notice I have already placed the box in level flight to 33,000 ft and he rises to it!!

Yes i can see that now in your first picture.

You do not need to use the altitudes in the FS2004 flightplan.

My advice would be use PFE without the SIDS/STARS until you are more experienced with it.

yes I will exprimentar but pfe 2000 leads right to the runway?

I'll try but pfe 2000 takes the runway correct?

paparomeu wrote:

yes I will exprimentar but pfe 2000 leads right to the runway?

If you use PFE without the STAR option enable, it will vector you to the runway.

I did flight test porto Portugal asturias spain without sids and stars my problems were the center continues until the target control should not be Spanish!!? sent me down there and spent over 33000ft destination ever!! ?
ha solution to this is not to go down!! only descends when fuel ends