OnCourse Software

Been running on 3.2.145 due to 3.22 not working yesterday. Started up this AM and auto update showed-up so I OK'd it. Installer seemed to run fine. Started PF3 (3.22) & P3D. PF3 came up fine but displayer would not connect. Could communicate with PF3 with no problem but displayer kept the red box open and was blank.

Went back to 2.1.145 and same as above, no displayer.
max

Sorry, here's the log.

Please attach your PF3_Display.INI file

Right. Was going to do that but checked it (latest) against an old backup and they were the same. Displayer has never not worked before. PF3 on networked PC and network is working fine.
max

That's the wrong file, I need to see the PF3_Display.INI which is in your PF3\PF3_Displayer folder, unless you're running it from another location

Sorry.

"currently using port" is at bottom of red box. Don't remember that being there...?
Thanks,
max

Nothing shows in com log either but I can communicate with ATC.

fixed it by rolling back to displayer exe from one of my backups from 18FEB24. exe file is dated 27AUG22. Everything works again.
Thanks,
max

Thanks for that but obviously you shouldn't need to do so... I plan to check it out myself today with the latest version.