OnCourse Software

I haven't been able to run 3.21.5 beta (I get an error window when I try - DaveM is aware of this ), so am on 3.21.0: in this version at least, when I have the option "Use QNH instead of Altimeter for non-US" unchecked (=off?), barometer settings are being given as 'Altimeter is 1013' instead of 'Altimeter is 29.92'. (With the option checked, I get 'QNH is 1013', which is correct of course.

Options #1, Trans Alt & Alt Baro Calls (at bottom), uncheck the small checkbox for each region if you prefer the baro calls in inches

OK, will look at that. I thought the setting I mentioned was 'global'. Thanks.

Later: Ah yes, now I see it, it all comes back to me (long time since I have actually had to set up PF3 from a fresh install)! I'd forgotten all about that page. Thanks again.