OnCourse Software

Hi,

I'm using PFE 3.10.3 with FS2020 and I have, regularly, in CP mode 2 (VCP handle freq changes and all comms), my VCP asking for higher/lower altitude due to turbulence even if there is nothing noticeable during flight.

Is there any way, on PFE settings, to prevent VCP to ask climb or descent request due to turbulence or, at least, strenghen turbulence detection to make it barely detectable ?

I searched onto this forum without finding so sorry if it has already been asked and answered.

Thanks

Soufiane wrote: *

Sat Jan 30, 2021 7:16 pm

Hi,

I'm using PFE 3.10.3 with FS2020 and I have, regularly, in CP mode 2 (VCP handle freq changes and all comms), my VCP asking for higher/lower altitude due to turbulence even if there is nothing noticeable during flight.

This sounds like a hotkey being triggered. Are you using MCE or voice recognition? That may be the cause, or there could be an issue or conflict with hotkey mapping. If it keeps happening please zip and post the debug_monitor.log file from the PF3\Logs folder so we can have a look.

Dan77 wrote: *

Sat Jan 30, 2021 9:46 pm

Soufiane wrote: *

Sat Jan 30, 2021 7:16 pm

Hi,

I'm using PFE 3.10.3 with FS2020 and I have, regularly, in CP mode 2 (VCP handle freq changes and all comms), my VCP asking for higher/lower altitude due to turbulence even if there is nothing noticeable during flight.

This sounds like a hotkey being triggered. Are you using MCE or voice recognition? That may be the cause, or there could be an issue or conflict with hotkey mapping. If it keeps happening please zip and post the debug_monitor.log file from the PF3\Logs folder so we can have a look.

Hi,

I checked hotkey mapping but it doesn't seem to explain my issue actually.
BTW, I posted my debug_monitor file to help figure out what's wrong.

Thanks

Soufiane wrote: *

Sun Jan 31, 2021 11:57 am

Dan77 wrote: *

Sat Jan 30, 2021 9:46 pm

Soufiane wrote: *

Sat Jan 30, 2021 7:16 pm

Hi,

I'm using PFE 3.10.3 with FS2020 and I have, regularly, in CP mode 2 (VCP handle freq changes and all comms), my VCP asking for higher/lower altitude due to turbulence even if there is nothing noticeable during flight.

This sounds like a hotkey being triggered. Are you using MCE or voice recognition? That may be the cause, or there could be an issue or conflict with hotkey mapping. If it keeps happening please zip and post the debug_monitor.log file from the PF3\Logs folder so we can have a look.

Hi,

I checked hotkey mapping but it doesn't seem to explain my issue actually.
BTW, I posted my debug_monitor file to help figure out what's wrong.

Thanks

My mistake, actually, I'm switching views onto FS2020 using hotkeys unfortunately.

You were right.

Thanks