OnCourse Software
http://www.ocs-support.co.uk/forums/

ATC stopped post Oceanic
http://www.ocs-support.co.uk/forums/viewtopic.php?t=3033
Page 1 of 1
Author:  mwa05 [ Fri Nov 02, 2018 1:17 pm ]
Post subject:  ATC stopped post Oceanic

I just did a YSSY-WSSS flight and the Program stopped post Oceanic and I proceeded in silence to destination. Manual descent requests and manually going to TWR frequency did not work. However, the program was still connected as I could get the ATIS, change closed caption, etc. Logs are attached.

I don't discount user error however I am not sure what that would be!

Thanks.

Mark

Author:  Dave March [ Sun Nov 04, 2018 11:02 am ]
Post subject:  Re: ATC stopped post Oceanic

The problem appears to be you were not tuned to the correct frequency. This was because you were not handed off and the reason for that I'm still looking into. Going forward if you use the PF3 Display utility it will show you the frequency you should be tuned to and should this problem occur again you could simply tune to the correct control frequency and manually make contact. I will address this in the next maintenance release.

Author:  mwa05 [ Mon Nov 05, 2018 8:39 pm ]
Post subject:  Re: ATC stopped post Oceanic

Thanks David, I will read up on using the display utility to check, for future flights. BTW I did the flight again a few days later albeit on a completely different ATS route and it worked fine, go figure!

Regards,

Mark

Edit - just read the manual re the Display Utility. Gold, amazing how you can use something everyday and not know of such little Easter eggs 🥚

Author:  Dave March [ Tue Nov 06, 2018 6:57 am ]
Post subject:  Re: ATC stopped post Oceanic

Yeah I know... I'm still finding little treasures and I developed it! But that's more down to failing memory! ;-)

Sent from my mobile using Tapatalk


Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited