OnCourse Software
http://www.ocs-support.co.uk/forums/

Configuration question for PF3 and MCE
http://www.ocs-support.co.uk/forums/viewtopic.php?t=2737
Page 1 of 1
Author:  PierreNantel [ Fri Oct 13, 2017 12:54 am ]
Post subject:  Configuration question for PF3 and MCE

I have red the manual for both software and I still have a very simple question? For MCE I have assign a yoke button to replicate the DEL key. In PF3 do I just activate the esc key and change it to the DEL, to match MCE? or I have to use both esc first to get PF3 ATC silences and then the yoke button to start PTT? The rest of the configuration I have found in the manual, but this part is not clear to me.

Pierre

Author:  RALF9636 [ Fri Oct 13, 2017 11:00 pm ]
Post subject:  Re: Configuration question for PF3 and MCE

Choose any normal character like a, b, c etc. (or Ctrl / shift combination) as PF3-PTT hotkey. Do not use special characters like , ; # etc. as those may cause problems with international keyboard layouts. I also would not use Esc.
Make sure no other action is assigned to that key in the sim or any other addon.

Then assign that key to your MCE-PTT button via FSUIPC.

Do not use the DEL key in MCE, only use the button.

So when pressing the MCE PTT button the PF3 PTT Hotkey is sent simultaneously.

Author:  PierreNantel [ Sat Oct 14, 2017 4:45 pm ]
Post subject:  Re: Configuration question for PF3 and MCE

Ok will try that

Thanks

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited