TheDuke wrote: * | Fri Apr 28, 2017 11:04 am |
So I waited for the taxi instructions from ATC to hit Ctrl+Shft+W. Nothing but my VCP replying to the taxi-instructions which was a very long one.
27-4-2017 14:40:02: 030 - Transcript: ' Hotel Tango 11 Juliet Kilo Tango 13 Tango 14
Sierra 14 Mike 10 November 7 November 6 Delta 3 Delta 2 Delta 1 Echo 1 Kilo 6
holding point, runway 02 Air Berlin 482 '
27-4-2017 14:40:36: 220 - ****** HotKey #13 detected!
27-4-2017 14:40:36: 220 - FS Screen : Comms busy, try again in a few seconds...
|
TheDuke wrote: * | Fri Apr 28, 2017 11:04 am |
When he was finished I tried Ctrl+Shft+W again. Nothing again.
PF3 detected that:
27-4-2017 14:40:51: 180 - ****** HotKey #13 detected!
27-4-2017 14:40:54: 210 - FS Screen : Use runway 2 - ILS ? - C/S/Y for Yes, or C/S/N for No
27-4-2017 14:41:21: 910 - ****** HotKey #13 detected!
27-4-2017 14:41:24: 260 - FS Screen : Use runway 2 - ILS ? - C/S/Y for Yes, or C/S/N for No
|
At this point you should use Ctrl-Shift-N for No to switch through the runways and Ctrl-Shift-Y for Yes to confirm the new runway.
Do you see these messages on your screen?
TheDuke wrote: * | Fri Apr 28, 2017 11:04 am |
TGS is not active, by the way.
This is what I thought at first
P.S.: To avoid having to wait for the long taxi instructions, I now use VCP mode #0 and switch to mode #2 when I get the correct runway.
P.P.S.: It was "only" ten minutes:
27-4-2017 14:51:40: 700 - Transcript: 'Air Berlin 482 Contact Tower on 118.1 ' |