OnCourse Software

Hi, I Fly out and into small airfields in Alaska.
I use mainly airfields from RTMM (Return to Misty`s Moorings)
I can generate a flight plan in P3D but PF3 does not recognise the departure airport and states it has no runway.
I re run the database in Pf3, and MakeRwys'.
Is there any advice you can give so as I can make flight plans to and from RTMM runways?

BJ from OZ

Sorry it should read "NO AIRPORT FOUND" from PF3.
I recently downloaded and installed Black Rapids Lodge, from RTMM.
Added scenery to P3D, ran MakeRwys, ran database in Pf3, .
I tried to create a flight from Fairbanks Alaska to Black Rapids but upon connecting PF3 it states it cannot find BRL1 (Black Rapids Lodge) in my database.

BJ from OZ

Check the instructions in makerunways (in the download). The default settings will only "capture" runways over a certain length. You will need to change these.

Look here:

viewtopic.php?f=8&t=2285&p=13297#p13297

Thanks for that, any idea where I would write this into makerwys?

Create a shortcut to makerwys.exe. Rightclick on the shortcut and open properties. Add />0 /water to the target path. Then start the shortcut.

Thanks for that, I've created the shortcut but I don't know where to put it in the shortcut.
Sorry to be a pain, I tried putting it in the target line, but it states it's invalid.
Where exactly do I write it in?

Regards BJ

This is my target path in the shortcut properties:

Q:\Prepar3D\MakeRwys.exe />0 /water

Hope this helps.

"F:\Lockheed Martin\Prepar3D v3\MakeRwys.exe" this is my target in the shortcut, do I do this ,"F:\Lockheed Martin\Prepar3D v3\MakeRwys.exe" />0 /water?
I've just tried this and applied it and it appeared to work, Ill try reloading the flight plan and se if it worked. THANK YOU

Yes that worked, I've just got to make sure I don't run Physics P3d as it also runs Makerwys.exe but only produces 63905 runways where the edited version produces 68378.
Can I replace the Makerwys.exe in Physics P3d with my edited version so it produces the same amount of runways?
Just did the flight to Black Rapids Lodge BRL1 from Fairbanks,
This will make RTMM airports much more enjoyable.
I than you very much.

BJ from OZ