OnCourse Software
http://www.ocs-support.co.uk/forums/

Hot Key modification
http://www.ocs-support.co.uk/forums/viewtopic.php?t=2898
Page 1 of 1
Author:  Yorkshire [ Mon May 28, 2018 7:04 pm ]
Post subject:  Hot Key modification

Hi

Have just installed PF3toXP from MCE and need to modify my keys so that all use CTRL+Shift so that no conflicts with XP. I can do this for all the keys except the 0 key. For some reason it won't allow me to modify. Is this built in to the program or is there something wrong at my end.

Thanks

John Metcalfe

Author:  ThomasAH [ Mon May 28, 2018 7:28 pm ]
Post subject:  Re: Hot Key modification

Yorkshire wrote: *  Mon May 28, 2018 7:04 pm
Have just installed PF3toXP from MCE and need to modify my keys so that all use CTRL+Shift so that no conflicts with XP. I can do this for all the keys except the 0 key. For some reason it won't allow me to modify. Is this built in to the program or is there something wrong at my end.
You can adjust the key codes in PF3.ini (and I'm assuming you're using PF3 despite this post being in the PFE forum) using the key codes listed in the FSUIPC documentation (FSUIPC4 for Advanced Users.pdf)
Ctrl+Shift+(Zero on the main keyboard) should be 3048
Ctrl+Shift+(Zero on the numeric keyboard with numlock on) should be 3096

So the PF3.ini entry should be Hotkey1=3048 or Hotkey1=3096

Author:  Yorkshire [ Mon May 28, 2018 9:16 pm ]
Post subject:  Re: Hot Key modification

Thanks for the response advice - realised I'd put it in the wrong forum! Discovered that for XPlane, Shift + 0 is free so have used that. Strange that it wont accept CTRL+Shift+0.

John

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited