Added Sept 2008.... version 2.6... which might help
ADDED another NEW option... PFE Resume... This allows you to resume a
flight at any point should PFE or FS fail mid-flight. PFE will now save
'restart' data periodically.
This feature is NOT active whilst you are on the ground and therefore you
cannot resume a flight from the destination or departure airports. Restart
data is collected from the point you receive your initial vectors from
Departure and ends at point of touchdown at your destination.
If your flight is cut short at anytime between these two points you can
resume the flight simply by pausing FS (assuming it’s still running) then
restarting PFE and selecting the ‘Last ADV’.
If FS crashes you will need to be able to reset FS back to the point of
failure. Auto save utilities are available for doing this, but PFE does not
save you FS data.
This new feature is OFF by default and full details on how to use it are in
the PFE manual found in the …\PFE\Help folder, which has been fully
updated with this release.