OnCourse Software

Unfortunately, when I try to install a cumulative update, I am unable to satisfactorily answer the question about the original installation - I moved to a new computer and don't have a clue as to how to answer this question.

Do I have to do a full uninstall - reinstall?

It appears that I may have the same problem - where does one find a copy of TGS.exe to place back into the main folder?

You stated: "According to the log 134.45 works correctly" However, I was only with them for less than 1 minute and then was assigned to New York - 134.65. I never got a response from them in spite of numerous efforts to contact them. When I got close to KRDG, I was able to contract the tower and ...

OK - thanks.

Maybe I don't wait long enough for the next transmission. My recollection is that I never have any further communication but perhaps I "panic" and switch to tower too early.

I'll run the flight again.

I figured out why PF3 was delaying contact with ATIS- Seems I inadvertently changed the setting that controls that. The failure to keep contact with ATC center is still evident - seems to be only on extended VFR flights. However, once near airport, the tower can be contacted. I understand the fact ...

Flight Plan - KTTN - HINDU - KRDG Couple of questions - - 1. General observation - Seems to take quite a bit of time for original connect to ATIS - 4:00 minutes in three tests I have run - doesn't seem to matter what airport 2 . Specific to this flight Clearance, ground, tower, departure, center ...

OK - I figured out what was happening. Even though I had ATC inactive in MSFS, it was still intercepting keystrokes and was interpreting the 1 hotkey as a request to change frequency (or whatever else it wanted the 1 key to do) which of course took me off the tower freq. thus I was unable to check ...

This problem reoccured on another flight On approach - turned over to tower (KTTN) - tuned to tower freq. Used 1 hotkey and my Com 1 radio was switched to a different frequency - this time 123.8. I checked everyplace I could think of in MSFS to see if there is any programming of the 1 key for the ...

On VFR flight plan - KLBE - KAGC
Approach turns me over to tower
Switch to tower freq.
Press the 1 Hotkey
My radio get switched to departure freq. of airport (119.35 - not from Com 1 standby) - even when flying to another airport - KAGC - KLBE for example

Logs attached

Thanks

Welcome John. Default key is Ctrl-Shift-\ I hope this helps, but do come back if you are still having an issue - some keyboard layouts seem to cause problems. Martin Martin, Thanks for the quick reply. Ctrl-Shift-\ was not recognized from my keyboard - I replaced it with the R key and now it is ...