OnCourse Software

Dave, I have been to hell and back trying to get to the bottom of ALL my problems with PF3 over the last couple of days and you are not going to believe me when I tell what I think the cause has been. The biggest problem was every time I ran PF3 it thought the sim rate was being set to 0, well not b...

Unfortunately it seems my PF3 is completely screwed and I am going to have to do a complete clean install which I hope will resolve on my issues. Every time I try a flight PF3 gets the same sim rate "set to 0 error", even though my sim rate is definitely at the default setting. So I will s...

The sim rate issue is bizarre, I do not even know how to change the sim rate, let alone set it back to normal. Did read, though, that the sim rate returns to normal at the start of every flight, so I thought OK, no problem, but the next flight the same sim rate error occurred in the PF3 log file. En...

Hi Dave, I have tried both 3.21.51 and now 3.21.50 to see if the TOD pause issue I reported was resolved, but I have not been able to get that far. With both these versions, I get the initial IFR Briefing message and then no other response, when I press 0 for clearance nothing, When I tune ATIS I ge...

Not handing me over from ground to tower on departure. Frequently

Never Pausing at TOD this has been the case for me for a few versions and not just the latest.

Stops communicating after being cleared for ILS. Seems to be happening frequently for me these days

Thanks in advance
Mark

Hi I now think the root cause of my problem is FSUIPC7 hanging and not the ATR. I have created an FSUIPC7 lua script so I can control all the main ATR AP modes using my GoFlight MCP PRO and there have been at least 2 occasions when FSUIPC7 has hung while I have been dialing up the altitude. I suspec...

Thanks Dave,
I now think this is a problem caused by FSUIP7 hanging ,so I will over there if it happens again.

One thing though, PF3 can restart a flight in a CTD. So could it not maintain it state in a MSFS disconnect situation allowing you to reconnect and carry on?

Thanks again
Mark

Hi Dave, What you are telling does not make any sense. I had not used PF3 for several months and just started using to test it out with the ATR which I do not think has anything to do with the problems I am having. The first flight I tried I did not get off the stand. When I connected PF3 to MSFS it...

The last time I tried a flight with the recently released MSFS ATR. PF3 stopped communicating half way through the fight. I was told that the reason was that the COM radio had been tuned away from the correct frequency. I did not do this and the PF3_Display no longer seems to work with MSFS. Instead...

OK, now I did not change the com radio frequency, However, I did consider if that was the problem, and I tried to run the PF3_Display tool, something I have not run in, I don't know how long, to check on the en route frequencies. But it would not run. I got the error that to run PF3_Display you need...