OnCourse Software

My apologies, a little too quick to start a new topic.
With a little more research I found my answer.
Running PF3_Register.exe made the difference.

dave

Have been away from PF3 for a while. Created a flightplan in simbrief tonight and when I tried to select it in PF3 I got an error message: "There was a problem whilst processing this flight plan! Please report this issue on the PF3 support forum ... Thank you for your assistance and we apologize for ...

Good morning! Had the same thing occur last night flying into CYMM. Thought I'd throw in my log to see if it would help figure this one out. Couple of other issues that I think are already being looked into: - ATC descended me too early. Ended up at 3000ft still 80nm back from CYMM - Communication ...

Thanks for the replies. Great to see! So this is where it ties into the debate about tying PF3 to navigraph or not. Correct me if I'm wrong; if I update my airac cycle then the SID/STAR entries I have made for an airport could/would change??? So it is best to enter the information on a flight by ...

With all the talk about the "Randomizer" it is time for me to get deeper in PF3 before I start trying to figure Randomizer out. I have been very satisfied with my experiences with PF3 default settings without getting into setting things up on the STAR/SID page. The one question that comes to me ...

POOF!!! Problem Solved.
Thanks for the quick reply.
Best product support!

Thanks
Dave

I am having problems after the latest update. I have PF3 on a networked PC. Everything starts up fine. I enter a flight plan from my host pc without issue. Then when I click on connect to FS, nothing happens; - The "connect to FS" doesn't grey out. When I click on "connect to FS" again it says I am ...

Thanks Dave. I believe I had contacted ground and was given taxi instruction. When I turned off the taxi way and on to the apron perhaps since I was so close to the gate I got no further instruction. Over the next couple of flights, I will see how it goes. Seem to have everything else sorted out so ...

Hi Dave, In this specific case I turned off the taxiway onto the apron and I must have been immediately within 50 meters of the gate already so not sure which of the two gates ahead of me I was suppose to go to. The error messages always seem to come up behind other windows that are open on the ...

Hi Dave, SUCCESSFUL FLIGHT CYYC to CYVR! All worked flawlessly. Key board problem resolved. All atc commands, all readbacks, no issues! Interestingly though I still got a PF3 error at the end which I submitted. The only thing that did not work perfectly was direction to my destination parking spot ...